Enterprise News

        Wearing prosthetic limbs, you should know the maintenance and maintenance Treasure Book

        2019-08-21 10:03:29 baiye 41

        As a mechanical product, prosthetic limb must be maintained and maintained, so how to rationalize the maintenance and maintenance of different parts of prosthetic limb? What conditions must be sent to a professional prosthetic rehabilitation center for maintenance and maintenance?



        Maintenance and Maintenance of Structural Parts


        (1) If the joint and joint of the prosthesis are loosened, it will affect the performance and sound. Therefore, the fixed screw and rivet of knee, ankle shaft screw and belt should be checked regularly to tighten in time. When the metal shaft is inflexible or noisy, it is necessary to add lubricating oil in time. After dampness, it should be dried in time and oil-filled to prevent rust.


        (2) The power and electrical system of EMG prosthesis avoids dampness, shock and stickiness. For complex and precise electric prosthetic hand, professional maintenance personnel should be sought.


        (3) When there is abnormal sound, indicating that the prosthetic parts are damaged, the reasons should be found out in time, proper maintenance should be carried out, and repair should be carried out in the prosthetic rehabilitation center if necessary. Especially when using skeletal lower limb prosthesis, the joints and connectors should be repaired in time. It is better to go to the prosthetic rehabilitation center regularly (for example, once every three months).



        Maintenance and Maintenance of Reception Cavity


        (1) Keep the inner surface of the receiving chamber clean. For the suction receptive cavity, it is directly in contact with the skin. If the surface of the receptive cavity is dirty, it will increase the risk of skin infection of the residual limb. Therefore, amputees should wipe the inside of the acceptance cavity before going to bed every night. Use a towel to soak in soapy water and then dry naturally. For the acceptance chamber of electromechanical prosthesis, water and damp air should be avoided and kept dry. The contact surface between electrodes and skin is easy to adhere to dirt and rust. Attention should be paid to keeping its surface clean. Prevent the faults and short circuit easily caused by wire breakage.


        (2) Attention should be paid to cracks in the receiving cavity. Fine cracks may occur on the inside of the resin acceptance chamber and sometimes the skin of the disabled limb may be injured. Cracks in the receiving chamber are easy to crack. At this time, when the acceptance cavity attachment viscera or resin deterioration, often will make smooth acceptance cavity surface uneven scar, especially when thigh suction acceptance cavity wall upper end of this situation, will injure the skin of the perineum, should pay more attention.


        (3) When the acceptance cavity is relaxed, the method of adding socks with stumps (no more than three layers) is used to solve the problem; if it is still too loose, one layer of felt can be attached to the four walls of the acceptance cavity to solve the problem. If necessary, replace the new receptive chamber.



        Maintenance of silicone sleeve / gel sleeve


        It is recommended to clean silicone gel / gel sleeve every day, wash with a little of non alkaline lotion, wipe the water and place it in a clean place to dry. It is not allowed to bake.


        Maintenance of Decorative Coat


        The front part of the knee joint in the foam decorative coat of the skeleton type thigh prosthesis is most likely to rupture. The user should pay attention to sticking and repairing in case of a small break. It can be strengthened by sticking strips on the inside so as to prolong its service life as far as possible. In addition, if you wear short-waisted socks, the socks in the lower leg are liable to be strangled by rubber bands. Therefore, even if wearing leg prosthesis, it is best to wear socks longer than the knee.


        Taking the maintenance and maintenance of electric prosthesis as an example, the requirements are as follows:


        (1) Prosthetics should not be overloaded in use to prevent damage to components;


        (2) The operator who does not understand shall not be disturbed;


        (3)Don't disassemble the machine parts at will.


        (4)If it is found that there is noise or abnormal noise in the mechanical part, the parts should be inspected, repaired and replaced in detail.


        (5) After one year of use, lubricating oil should be added to the transmission part and the rotating shaft.


        (6) Battery voltage should not be less than 10V. If the prosthetic limb moves slowly or cannot start, it should be charged in time.


        _Prevent the crossing and twisting of the connecting wires of electrical components, avoid the leakage of electricity or short circuit caused by insulation damage.


        Safe use of prosthetic limbs


        It is recommended that prosthetic limb users be reexamined once a year. If the prosthetic limb is faulty, it must be repaired in time and not disassembled by itself.


        国产成人不卡亚洲精品91| 亚洲国产区男人本色在线观看| 亚洲高清有码中文字| 亚洲综合视频在线| 亚洲国产成人片在线观看| 国产亚洲精久久久久久无码77777 国产亚洲精品成人AA片新蒲金 | 国产亚洲情侣久久精品| 亚洲日本天堂在线| 国产成人亚洲综合一区| 亚洲午夜在线播放| 狠狠色伊人亚洲综合网站色| 亚洲午夜精品在线| 亚洲人成777在线播放| 亚洲春色另类小说| 亚洲国产中文在线二区三区免| 亚洲黄色网站视频| 亚洲精品国产电影午夜| 亚洲人成网站在线播放影院在线| 亚洲av中文无码乱人伦在线r▽| 亚洲一区AV无码少妇电影☆| 最新国产AV无码专区亚洲| 久久久无码精品亚洲日韩软件| 国产精品亚洲自在线播放页码| 亚洲AV一二三区成人影片| 亚洲卡一卡二卡乱码新区| 亚洲综合精品成人| 亚洲日本VA午夜在线影院| 亚洲欧美第一成人网站7777 | 亚洲天堂2017无码中文| 亚洲娇小性色xxxx| 亚洲人成电影网站色www| 亚洲av永久中文无码精品| 婷婷亚洲综合五月天小说在线| 亚洲国产成人a精品不卡在线| 亚洲国产aⅴ综合网| 亚洲小说区图片区另类春色| 亚洲成a人片在线观看日本| 亚洲美女一区二区三区| 亚洲a级在线观看| 亚洲成AV人片高潮喷水| 国产亚洲成在线播放va|